iVAPO 2 in 1 Charging Holder
iVAPO 2 in 1 Aluminum Charging Holder for Apple Watch Series 4/3/2/1 and iPhone Series X/8/7/6, Lightning Cable Not Included.
$35.99 $14.99
  • Note: Global Universal
  • Brand: iVAPO
  • Product Code: 2011168
  • Availability: In Stock

Unique 2 in 1 Holder
iVAPO iPhone and Apple Watch Dock is finely crafted from solid aluminum, which is sturdy enough to perform a stable stand. Sleek 2 in 1 stand supports comfortable vertical viewing angle for Facetime and allows for a better charge. It holds the iPhone and Apple Watch perfectly and offers great organization to hide the clutter of charging cables.


Made for Apple Watch
iVAPO stand is specially designed for Apple Watch Series 3/Series 2/Series 1/Sport/Edition 38mm/42mm. The Precise cutout has anti-slip rubber design for non-slip and no scratches.

iPhone Holder
Little Back holder supports the device vertically, providing you a perfect viewing angle for iPhone X/iPhone 8/iPhone 8 Plus/iPhone 7/iPhone 7 Plus/iPhone 6s/iPhone 6s Plus/iPhone 5/iPhone 5s/iPhone 5c.

NOTE: Bare device without any case are recommended while charging.

Assembly Required: 
This item needs to be assembled by yourself before using. There are screws and a small screwdriver that comes with the stand to help you finish the installation.



Installation Steps:
1. Use the screwdriver to untie 4 screws on the bottom plate, which allows an access to the cable management inside
2. For iPhone: Loosen the adjustable screw to place your iPhone Lightning Cable inside the slot and then tighten the adjustable screw to immobilize the cable
3. For Apple Watch: Loosen the screws under the Apple Watch Component; Remove the magnetic charger holder to start your cable management.
4. Slide off the metal piece and insert your Apple Watch magnetic charger. Place in the charger from the bottom first. Then line up the cable inside the cabling channel and re-insert the metal piece.
5. Adjust all cables inside the cable organizing base and pull them through the slot in the back of the base. Place the bottom plate back and tighten up all four screws with the screwdriver.

Adjustable Charging Base
You can angle the phone charger piece to adapt to your iPhone and reduce stress on plug by leaning phone back. It’s easier for you to measure how far the adapter needs to stick out by adjusting the height of the lightning charger while assembling.

Perfectly Fit for Some Thin Cases
The base lightning port is actually adjustable to accommodate cases of different thicknesses, big enough for the lightning cable to fit into some thin cases, but it depends on the thickness of the case, thus not promise to fit all.

Anti-slip Mat on the Bottom
Slip-resistant mat absorbed on the bottom of the base enhances the stability to keep the whole unit more secure as well as protecting the table top from scratches.

Write a review

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha